HughesNet Standard Installation

Here is what is included:

Mount the dish to an approved structure at least five feet off the ground as required by FCC regulations, using HUGHES standard roof, and/or wall mounting brackets.

Mount to a one-story surface.

Install a coaxial cable jack in the room where the HughesNet System will be located.

Route two exterior RG-6 coaxial cables (each up to 100 feet in length) from the dish into the house, and to the coaxial cable jack.

Provide and install the hardware required to properly ground your HughesNet System.

Install the HughesNet modem and connect it to your PC.

Verify receipt of satellite signal.

Commission your HughesNet account.

The following items are not included in standard installation:

Complex/custom installations that may result in additional fees.

Make sure you discuss any custom work with your installer before they begin the job.

Custom work including, but not limited to:

Moldings or cosmetic hardware to help hide cables
Non-penetrating roof, pole, or chimney mounts

Installation of DIRECTV receivers and cables and/or complex connections to stereo/audio components.

Removal and/or repair of previously mounted equipment (a signed Waiver of Liability must be included to perform this work).

Mounting to a roof surface that exceeds one story in height Verify receipt of satellite signal.

Non-penetrating roof mount, pole mount, or chimney mount.